Battery Test & Automation Solution

Brochure: Battery Test and Automation Solutions (pdf/2.3MB)

Battery Pack/Module Test Solution

Battery Test and Automation Solutions

 


 

DC Impedance Measurement for Battery Cell

The battery pack for electric vehicles requires the battery cells be paralleled for large current use. An important parameter is the impedance consistency of the battery cell since battery life may be affected if the impedance is not consistent. The DC impedance test solution offered by Chroma sets the discharge current change (ΔI) and measures the voltage change (ΔV), and then calculates the battery's internal resistance using ΔV/ΔI as shown in the figure below.

Chroma's 63600 Series Electronic Loads supply a 6V/16V/80V voltage ranges with 0.025% + 0.01%F.S. accuracy to measure the small changes of a battery cell. Each module is able to perform 80A low voltage loading and up to 400A loading when 5 modules are paralleled. The loads feature a high speed data digitizing function that captures the voltage and current every 2us with a maximum 4096 measurements for digital waveform sampling.

Users can conduct the test using our Battery DCIR Measurement Software with Chroma 63600 Series Electronic Loads. With the software users can set DC impedance measurement pattern, edit the discharge procedure to test the DC impedance of a battery cell automatically when under different SOC, and generate a report of the outcome.


[Connection Diagram ]

 


[Test sequences Editing of Battery DCR Measurement Software]


[Voltage & Current Waveform Analysis of Battery DCR Measurement Software]

 


[Test Report ]

Product Information : Model 63600 series Programmable DC Electronic Load


 

Battery Module & Pack Charge/Discharge Test Software

Chroma provides Battery Charge/Discharge Test Software that integrates the DC Source and Electronic Load to perform battery pack simulation testing. This system facilitates the R&D/QA to test the battery for capacity, discharge performance to get the C-V curve under different discharge rates, and endurance in cycles.

Functions of the Battery Charge/Discharge Test Software include editing test sequences, loops, and stop conditions. All tested voltage/current/power/capacity data is recorded in a file for analysis when finishing the test.


[Setting & monitor software ]

 


[Test Report]


 

Dynamic Current Waveform Simulation Test for Battery Pack

The charge/discharge waveform is irregular for EV/HEV battery applications. Although various batteries capacities are labeled the same, the discharge rate varies with materials used that cause driving distances to be different. Thus, it is necessary to use the actual current waveform to perform battery testing for performance evaluation which can serve as the basis for battery materials selection or BMS design.

The advanced Dynamic Current Waveform Simulation Software provided by Chroma is able to read actual recorded battery charge/discharge waveform data in Excel format and use a digital/analog converter to control the Electronic Load and DC power supply to perform the same current. This allows both automotive and battery pack manufacturers to simulate the application of irregular battery discharge and conduct repetitive tests in the lab rather than perform costly real road tests every time endurance evaluation is required or analysis is needed to test the material characteristics of a battery cell.

 


[main page]

 


[Record the current waveform during road test]

 


[Connecting diagram of the dynamic charge and discharge]


 

Using dynamic current waveform to simulate driving charge & discharge test

In the actual application of power battery pack, the discharge waveform is irregular; thus actual current waveform is required for battery discharge test as the base for evaluating the battery performance, material and BMS design.

The user is able to simulate irregular charge and discharge of battery for repetitive testing without conducting actual road test.

The simulation test can be applied to dierent elds such as vehicle start battery, hand starting tool, system factory 3D mark tests.